Lockformer Collar Maker
- Manufacturer:
- Lockformer
- Condition:
- NEW
- Machine Location:
- F.O.B Factory
Save time and money by combining notching, beading, crimping and rolling in one operation. For complete round starting collars 3 to 14 inches in diameter out of 24-30 gauge galvanized steel, the Lockformer Collar Maker is the perfect tool. All it takes is one pass! Just cut to width and length or use scrap. This machine uses either 3" or 6" width blanks with simple movement of the crimp roll.
- Model: Collarmaker (dove tail with tabs)
- Capacity: 24-30 gauge
- Motor/Voltage: 3/4 hp, 115 volt, single phase Drive - V-belt
- Speed: 30 fpm
- Dimensions: Length - 20" Width - 22" Height - 36"
- Weight: 300 lbs
- Tab-notch depth: 5/8" standard, adjustable to 3/4"
- Tab-notch spacing: Approx. 3/4" center
Save time and money by combining notching, beading, crimping and rolling in one operation. For complete round starting collars 3 to 14 inches in diameter out of 24-30 gauge galvanized steel, the Lockformer Collar Maker is the perfect tool. All it takes is one pass! Just cut to width and length or use scrap. This machine uses either 3" or 6" width blanks with simple movement of the crimp roll.
- Model: Collarmaker (dove tail with tabs)
- Capacity: 24-30 gauge
- Motor/Voltage: 3/4 hp, 115 volt, single phase Drive - V-belt
- Speed: 30 fpm
- Dimensions: Length - 20" Width - 22" Height - 36"
- Weight: 300 lbs
- Tab-notch depth: 5/8" standard, adjustable to 3/4"
- Tab-notch spacing: Approx. 3/4" center