Iowa Precision PRO-XVI - Vertical Whisper-Loc
The PRO-XVI is equipped with push button motor controls for quick-change duct lengths and is chain driven!
- Manufacturer:
- Iowa Precision Industries
- Condition:
- NEW
- Machine Location:
- F.O.B Factory
The PRO-XVI is equipped with push button motor controls for quick-change duct lengths and is chain driven!
- Capacity: 16 gauge
- Other: Duct Length: 3, 4, 5, 6 ft (914/1219/1524/1829mm)
- Motor/Voltage: 2 HP - 220/1/60
- Dimensions: Length - 96", Width - 35", Height - 32½"
- Weight: 1,550 lbs
- Closes duct work - whether Pittsburg or slip and drive - seams in a fraction of the time
- Motorized control moves the clamp and slide block,as a unit, for faster set up - one handed
- Greatly reduced noise levels
- Minimal floor space required
- Micro-processor controlled for ease of operation
- Low maintenance 220 V single phase 2 HP (1.5 kw)
- Self-contained 10-gallon (38 liter) hydraulic unit
- The Whisperloc-PRO16 closes seams in ducts only requiring a minimal of hammer over top and bottom to assure straight and complete seaming
- Unlike competitive models that require extensive manual hammer over in Pittsburgh and full length hammer over of at least 45° in slip and drive
- Seams from top and bottom to the middle to avoid run out and incomplete seaming of full-travel models
The PRO-XVI is equipped with push button motor controls for quick-change duct lengths and is chain driven!
- Capacity: 16 gauge
- Other: Duct Length: 3, 4, 5, 6 ft (914/1219/1524/1829mm)
- Motor/Voltage: 2 HP - 220/1/60
- Dimensions: Length - 96", Width - 35", Height - 32½"
- Weight: 1,550 lbs
- Closes duct work - whether Pittsburg or slip and drive - seams in a fraction of the time
- Motorized control moves the clamp and slide block,as a unit, for faster set up - one handed
- Greatly reduced noise levels
- Minimal floor space required
- Micro-processor controlled for ease of operation
- Low maintenance 220 V single phase 2 HP (1.5 kw)
- Self-contained 10-gallon (38 liter) hydraulic unit
- The Whisperloc-PRO16 closes seams in ducts only requiring a minimal of hammer over top and bottom to assure straight and complete seaming
- Unlike competitive models that require extensive manual hammer over in Pittsburgh and full length hammer over of at least 45° in slip and drive
- Seams from top and bottom to the middle to avoid run out and incomplete seaming of full-travel models